Pressure iron, household iron or lighter:

1. Peel off the white substrate with patterns underneath the hot stamping pattern, then place the adhesive paper with the diamond pattern on the clothes where you think it is suitable, flatten it with your hand, and make the adhesive paper with the diamond pattern stick to the clothes. [The sticky side is facing downwards]

2. Set the electric iron to the "cotton" level [equivalent to 150 degrees], and do not use steam or water on the steam iron. Dry ironing is sufficient. Place the clothes on a relatively flat surface, and sometimes to iron them more firmly, you can place one or two layers of towels on top of the surface. Press the iron firmly onto the hot stamping for about thirteen seconds. If the hot stamping is too large and the iron cannot cover it all at once, move the iron repeatedly on the hot stamping to evenly heat the entire image. At the same time, the ironing time is correspondingly extended.

3. After ironing, wait for the hot stamping to cool down before removing the surface layer of adhesive paper, and a beautiful hot stamping operation is completed.

Attention: Because most electric irons come with steam, there are small holes under the iron that affect heating. Therefore, when ironing, it is necessary to move the iron back and forth to ensure even heating. This way, the hot stamping will be firm.

Tools required for attachment hot stamping:

Hot stamping iron

Use a specialized hot stamping iron, following the same process as described above. For the hot stamping of large diamonds, it is necessary to press and heat from the back of the fabric.

Hot stamping tool

Mark the location where hot stamping is required, use a hot stamping tool to suck up the drill one by one and heat it in the marked position. This method can be used directly without using hot paper to create a hot stamping image beforehand. It can also be placed in non flat areas, such as shoes, bags, etc.

It can even be used on nails. It can also be used for nail inlay, phone diamond pasting.,

lighter

Prepare hot drills, lighters, and tweezers. Mark the areas that require hot drilling; Flip the hot drill to the front; Use tweezers to pick up the hot drill, and then use a fire machine to burn it on the rubber base for a while. The larger the drill, the longer it will last until the rubber melts, and then place it in the marked area; Just wait for the glue to dry.